The fuselage wood arrived over the last week so I've started building out a side... the bottom scarf joint has been a major thorn in my side... the geometry was a little complex and the plans/directions are very vague at this point in that one has to 'guesstimate' where to start the scarf joint as it doesn't specify in the plans or directions. Plans indicated a minimum 6" scarf so I went with 7.25." I finally got the geometry correct and am just dry fitting the joints to get them as close to perfect as I can... the good news is the second one is just a trace of this one, so should be very fast. Also, this is only the left scarf, there's still a right hand scarf to figure out.